D-Link xStack DGS-3620 Series - Page 168

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
163
DGS-3620-28PC:admin# show bfd
Command: show bfd
BFD Global State : Disabled
BFD Interface Setting
MinTxInt - Desired Minimum TX Interval
MinRxInt - Required Minimum RX Interval
Interface Name MinTxInt(ms) MinRxInt(ms) Multiplier Slow time(ms)
--------------- ------------ ------------ ---------- -------------
System 100 50 5 1000
Total Entries: 1
DGS-3620-28PC:admin#
11-5 show bfd neighbor
Description
This command is used to display the BFD neighbor information on the Switch.
Format
show bfd neighbor {ipif <ipif_name 12> | ipaddress <ipaddr> | protocol [ospf | vrrp] | details}
Parameters
ipif - (Optional) Specifies the IP interface to display.
<ipif_name 12> - Enter the IP interface's name here. This name can be up to 12 characters
long.
ipaddress - (Optional) Specifies to display the BFD neighbor information of the specified IP
address.
<ipaddr> - Enter the IP address used here.
protocol - (Optional) Specifies to display the BFD neighbor information of the specified protocol
owner.
ospf - Specifies to display OSPF BFD neighbor information.
vrrp - Specifies to display VRRP BFD neighbor information.
details - (Optional) Specifies to display more detailed BFD neighbor information.
Restrictions
None.
Examples
This example show how to display the BFD neighbors: