D-Link xStack DGS-3620 Series - Config Dst

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1218
DGS-3620-28PC:admin# config time 30jun2003 16:30:30
Command: config time 30jun2003 16:30:30
Success.
DGS-3620-28PC:admin#
115-7 config time_zone
Description
This command is used to change time zone settings.
Format
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>} (3)
Parameters
operator - Specifies the operator of the time zone.
+ - Positive.
- - Negative.
hour - Specifies the hour of the time zone.
<gmt_hour 0-13> - Enter the hour of the time zone between 0 and 13.
min - Specifies the minute of the time zone.
<minute 0-59> - Enter the minute of the time zone between 0 and 59.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the time zone:
DGS-3620-28PC:admin#config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
DGS-3620-28PC:admin#
115-8 config dst
Description
This command is used to change Daylight Saving Time settings.
Format
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-sat> |
s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-4, last> | e_day
<end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90