D-Link xStack DGS-3620 Series - Show Loopdetect; Show Loopdetect Ports

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
746
62-5 show loopdetect
Description
This command is used to display the switch’s current loop detection configuration.
Format
show loopdetect
Parameters
None.
Restrictions
None.
Example
To display the switch’s current loop detection configuration:
DGS-3620-28PC:admin#show loopdetect
Command: show loopdetect
LBD Global Settings
---------------------------
Status : Disabled
Mode : Port-based
Interval : 10 sec
Recover Time : 60 sec
Trap State : None
Enabled VLANs : 1-4094
Log State : Enabled
Function Version : v4.05
DGS-3620-28PC:admin#
62-6 show loopdetect ports
Description
This command is used to display the switch’s current per-port loop detection configuration and
status.
Format
show loopdetect ports {<portlist>}
Parameters
<portlist> - (Optional) Specifies a range of ports to be displayed.