D-Link xStack DGS-3620 Series - Config Accounting Service

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
87
4-39 config accounting service
Description
This command is used to configure the state of the specified RADIUS accounting service.
Format
config accounting service [network | shell | system] state [enable {[radius_only |
method_list_name <string 15> | default_method_list]} | disable]
Parameters
network - Specifies that when enabled, the Switch will send informational packets to a remote
RADIUS server when 802.1X, WAC and JWAC port access control events occur on the
Switch. By default, the service is disabled.
shell - Specifies that when enabled, the Switch will send informational packets to a remote
RADIUS server when a user either logs in, logs out or times out on the Switch, using the
console, Telnet, or SSH. By default, the service is disabled.
system - Specifies that when enabled, the Switch will send informational packets to a remote
RADIUS server when system events occur on the Switch, such as a system reset or system
boot. By default, the service is disabled.
state - Specifies the state of the accounting service.
enable - Enable the specified accounting service.
radius_only - Specifies that the accounting service should only use the RADIUS group
specified by the config radius add <server_index 1-3> [<server_ip> | <ipv6addr>]”
command.
method_list_name - Specifies that the accounting service should use the AAA user-
defined method list specified by the “create accounting method_list_name <string 15>”
command.
<string 15> - Enter the method list name used here. This name can be up to 15
characters long.
default_method_list - Specifies that the accounting service should use the AAA default
method list.
disable - Disable the specified accounting service.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the state of the RADIUS accounting service shell to enable:
DGS-3620-28PC:admin# config accounting service shell state enable
Command: config accounting service shell state enable
Success
DGS-3620-28PC:admin#
4-40 config accounting service command
Description
This command is used to configure the state of the specified accounting service.