D-Link xStack DGS-3620 Series - Config Backup

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1092
DGS-3620-28PC:admin#create backup config time_range range_1 filename bk-config-
1
Command: create backup config time_range range_1 filename bk-config-1
Success.
DGS-3620-28PC:admin#
To create a backup schedule on time range” range_2”:
DGS-3620-28PC:admin#create backup log time_range range_2 filename bk-config-2
state enable
Command: create backup log time_range range_2 filename bk-config-2 state enable
Exceeded maximum number (15) of schedules for backup configuration or log.
DGS-3620-28PC:admin#
98-2 config backup
Description
This command is used to enable or disable a schedule backup.
Format
config backup [config | log] time_range <range_name 32> filename <pathname> state
[enable | disable]
Parameters
config - Backup the configuration on schedule.
log - Backup the log on schedule.
time_range - The time range for the scheduled backup of the configuration or log.
<range_name 32> - Enter the name of this time range entry. The maximum length is 32
characters.
Filename - The backup filename of the configuration or log.
<pathname> - Enter the path name of backup filename of the configuration or log.
State - Enable or disable the scheduled backup when schedule is created. If “state” is not
specified, the schedule will be disabled.
enable - Configure the scheduled backup state to enable.
disable - Configure the scheduled backup state to disable.
Restrictions
Only Administrators, Operators can issue this command.
Example
To enable a backup schedule on time range” range_1”
DGS-3620-28PC:admin#config backup log time_range range_1 filename bk-des-log
state enable
Command: config backup log time_range range_1 filename bk-des-log state enable