xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1305
Example
To enable the WAC function:
DGS-3620-28PC:admin#enable wac
Command: enable wac
Success.
125-2 disable wac
Description
This command is used to disable the WAC function.
Format
disable wac
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable the WAC function:
DGS-3620-28PC:admin#disable wac
Command: disable wac
Success.
125-3 config wac authorization attributes
Description
This command is used to configure the acceptance of an authorized configuration. When the
authorization is enabled for WAC’s RADIUS, the authorized data assigned by the RADUIS server
will be accepted if the global authorization network is enabled. When the authorization is enabled
for WAC’s local, the authorized data assigned by the local database will be accepted.
Format
config wac authorization attributes {radius [enable | disable] | local [enable | disable]}(1)
To Next Page
Loading...
Need help?
General