D-Link xStack DGS-3620 Series - Chapter 68 MLD Proxy Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
783
Chapter 68 MLD Proxy
Commands
enable mld_proxy
disable mld_proxy
config mld_proxy downstream_if [add | delete] vlan [<vlan_name 32> | vlanid <vidlist>]
config mld_proxy upstream_if {vlan [<vlan_name 32> | vlanid <vlanid 1-4094>] | router_ports
[add | delete] <portlist> | source_ip <ipv6addr> | unsolicited_report_interval <sec 0-25>}(1)
show mld_proxy {group}
68-1 enable mld_proxy
Description
This command is used to enable the MLD proxy on the switch.
Format
enable mld_proxy
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the MLD proxy:
DGS-3620-28PC:admin#enable mld_proxy
Command: enable mld_proxy
Success.
DGS-3620-28PC:admin#
68-2 disable mld_proxy
Description
This command is used to disable the MLD proxy on the switch.
Format
disable mld_proxy