D-Link xStack DGS-3620 Series - Chapter 125 Web-Based Access Control (WAC) Commands; Enable Wac

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1304
Chapter 125 Web-based Access
Control (WAC)
Commands
enable wac
disable wac
config wac authorization attributes {radius [enable | disable] | local [enable | disable]}(1)
config wac ports [<portlist> | all] {state [enable | disable] | aging_time [infinite | <min 1-1440>] |
idle_time [infinite | <min 1-1440>] | block_time [<sec 0-300>]}(1)
config wac method [local | radius]
config wac default_redirpath <string 128>
config wac clear_default_redirpath
config wac virtual_ip {<ipaddr> | <ipv6addr>}
config wac switch_http_port <tcp_port_number 1-65535> {[http | https]}
create wac user <username 15> {[vlan <vlan_name 32> | vlanid <vlanid 1-4094>]}
delete wac [user <username 15> | all_users]
config wac user <username 15> [vlan <vlan_name 32> | vlanid <vlanid 1-4094> | clear_vlan]
show wac
show wac ports {<portlist>}
show wac user
show wac auth_state ports {<portlist>}
clear wac auth_state [ports [<portlist> | all] {authenticated | authenticating | blocked} | macaddr
<macaddr>]
config wac authentication_page element [default | page_title <desc 128> | login_window_title
<desc 64> | user_name_title <desc 32> | password_title <desc 32> | logout_window_title
<desc 64> | notification_line <value 1-5> <desc 128>]
show wac authenticate_page
config wac trap state [enable | disable]
125-1 enable wac
Description
This command is used to enable the WAC function.
Format
enable wac
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.