D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
290
hyphen - Specifies using the “-“ as delimiter, the format is: AA-BB-CC-DD-EE-FF
colon - Specifies using the “:“ as delimiter, the format is: AA:BB:CC:DD:EE:FF
dot - Specifies using the “.“ as delimiter, the format is: AA.BB.CC.DD.EE.FF
none - Specifies not using any delimiter, the format is: AABBCCDDEEFF
number - (Optional) Specifies the delimiter number used.
1 - Single delimiter, the format is: AABBCC.DDEEFF
2 - Double delimiter, the format is: AABB.CCDD.EEFF
5 - Multiple delimiter, the format is: AA.BB.CC.DD.EE.FF
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the MAC address format to IETF style:
DGS-3620-28PC:admin#config authentication mac_format case uppercase delimiter
hyphen number 5
Command: config authentication mac_format case uppercase delimiter hyphen
number 5
Success.
DGS-3620-28PC:admin#
19-5 config authentication ports
Description
This command is used to configure authorization mode and authentication method on ports.
Format
config authentication ports [<portlist> | all] {auth_mode [port_based | host_based {vlanid
<vid_list> state [enable | disable]}] | multi_authen_methods [none | any | dot1x_impb |
impb_jwac | impb_wac | mac_impb]}(1)
Parameters
<portlist> - Enter a port or range of ports to configure.
all - Specifies to configure all ports.
auth_mode - (Optional) The authorization mode is port-based or host-based.
port-based - If one of the attached hosts pass the authentication, all hosts on the same port
will be granted access to the network. If the user fails the authorization, this port will keep
trying the next authentication.
host-based - Specifies to allow every user to be authenticated individually.
vlanid - (Optional) Specifies the VLAN ID used for this configuration.
<vid_list> - Enter the VLAN ID used for this configuration here.
state - (Optional) Specifies whether the authorization mode will be enabled or disabled.
enable - Specifies that the authorization mode will be enabled.
disable - Specifies that the authorization mode will be disabled.
multi_authen_methods - (Optional) Specifies the method for compound authentication.
none - Specifies that compound authentication is not enabled.
any - Specifies if any of the authentication methods (802.1X, MAC, and JWAC/WAC) pass,

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English