D-Link xStack DGS-3620 Series - Page 1141

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1136
Parameters
<ipv6addr> - (Optional) Specifies the v6host IP address.
Note: If no parameter is specified, all SNMP IPv6 hosts will be displayed.
Restrictions
None.
Example
To display the recipient for which the traps are targeted:
DGS-3620-28PC:admin#show snmp v6host
Command: show snmp v6host
SNMP Host Table
------------------------------------------------------------------
Host IPv6 Address : 3000::105
SNMP Version : V2c
Community Name/SNMPv3 User Name : community3
UDP Port : 162
Total Entries: 1
DGS-3620-28PC:admin#
102-20 enable community_encryption
Description
This command is used to enable the encryption state on the SNMP community string.
Format
enable community_encryption
Parameters
None.
Restrictions
Only Administrator level users can issue this command.
Example
To enable the encryption state on an SNMP community string:
DGS-3620-28PC:admin# enable community_encryption