D-Link xStack DGS-3620 Series - Page 1294

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1289
122-5 show vlan_counter statistics
Description
This command is used to display the VLAN level traffic statistics.
Format
show vlan_counter statistics {[vlan <vlan_name> | vlanid <vidlist>] {ports <portlist>}} {[rx |
tx]}
Parameters
vlan - (Optional) Specifies the VLAN name that will be used for this display.
<vlan_name> - Enter the VLAN name that will be used for this display.
vlanid - (Optional) Specifies the VLAN ID that will be used for this display.
<vidlist> - Enter the VLAN ID that will be used for this display.
ports - (Optional) Specifies the list of ports that will be used for this display.
<portlist> - Enter the list of ports that will be used for this display.
rx - (Optional) Specifies that the statistics to be displayed is counted on ingress traffic.
tx - (Optional) Specifies that the statistics to be displayed is counted on egress traffic.
Restrictions
None.
Example
To display the VLAN counter statistics:
DGS-3620-28PC:admin#show vlan_counter statistics
Command: show vlan_counter statistics
VLAN Port Frame Type Frames/Bytes Frames/Bytes Per Sec
---- ---- -------------------- ---------------------- ---------------------
-
1 3 RX Broadcast(Packet) 0 0
2 3 RX Multicast(Packet) 0 0
1 3 TX Broadcast(Packet) 0 0
4 5 TX Unicast(Packet) 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh