D-Link xStack DGS-3620 Series - Page 1293

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1288
Example
To delete all of the control entries for both ingress and egress traffic:
DGS-3620-28PC:admin#delete vlan_counter all
Command: delete vlan_counter all
Success.
DGS-3620-28PC:admin#
122-4 show vlan_counter
Description
This command is used to display the VLANs traffic flow statistics.
Format
show vlan_counter {[vlan <vlan_name> | vlanid <vidlist>]} {[rx | tx]}
Parameters
vlan - (Optional) Specifies the VLAN name that will be used for this display.
<vlan_name> - Enter the VLAN name that will be used for this display.
vlanid - (Optional) Specifies the VLAN ID that will be used for this display.
<vidlist> - Enter the VLAN ID that will be used for this display.
rx - (Optional) Specifies that the control entries for ingress traffic will be displayed.
tx - (Optional) Specifies that the control entries for egress traffic will be displayed.
Restrictions
None.
Example
To display the VLAN counter information:
DGS-3620-28PC:admin#show vlan_counter
Command: show vlan_counter
VLAN Frame Type Ports
---- -------------------- ---------------------------------------------------
-
1 RX Broadcast(Packet) 3
2 RX Multicast(Packet) 3
1 TX Broadcast(Packet) 3
4 TX Unicast(Packet) 5
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh