D-Link xStack DGS-3620 Series - Page 1292

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1287
rx - (Optional) Specifies that the statistics for ingress traffic will be cleared.
tx - (Optional) Specifies that the statistics for egress traffic will be cleared.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear all of the statistics gathered by the control entries:
DGS-3620-28PC:admin#clear vlan_counter statistics all
Command: clear vlan_counter statistics all
Success.
DGS-3620-28PC:admin#
122-3 delete vlan_counter
Description
This command is used to delete the control entry for VLAN traffic flow statistics.
Format
delete vlan_counter [all | [vlan <vlan_name> | vlanid <vidlist>] [all | ports <portlist> [all |
[all_frame | broadcast | multicast | unicast] [packet | byte]]]] {[rx | tx]}
Parameters
all - Specifies that all control entries will be deleted.
vlan - Specifies the VLAN name that will be used for this configuration.
<vlan_name> - Enter the VLAN name that will be used for this configuration.
vlanid - Specifies the VLAN ID that will be used for this configuration.
<vidlist> - Enter the VLAN ID that will be used for this configuration.
all - Specifies that all ports will be used for this configuration.
ports - Specifies the list of ports that will be used for this configuration.
<portlist> - Enter the list of ports that will be used for this configuration.
all - Specifies that all control entries in specified ports to be deleted.
all_frame - Specifies that the frame type of the control entry to be deleted is all.
broadcast - Specifies that the frame type of the control entry to be deleted is broadcast.
multicast - Specifies that the frame type of the control entry to be deleted is multicast.
unicast - Specifies that the frame type of the control entry to be deleted is unicast.
packet - Specifies that the statistic of the control entry to be deleted is based on packets.
byte - Specifies that the statistic of the control entry to be deleted is based on bytes.
rx - (Optional) Specifies that the control entries for ingress traffic to be deleted.
tx - (Optional) Specifies that the control entries for egress traffic to be deleted.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.