xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1043
To configure the traffic scheduling on CoS queue 1, with a weight value of 25, on port 1:10:
DGS-3620-28PC:admin# config scheduling ports 1:10 1 weight 25
Command: config scheduling ports 1:10 1 weight 25
Success.
91-6 config scheduling_mechanism
Description
This command is used to configure the traffic scheduling mechanism for each CoS queue.
Format
config sc
heduling_
m
echanism {por
ts
[<portlist>
| all]}
[strict | wrr]
Parameters
ports - (Optional) Specifies the range of ports to be configured.
<portlist> - Enter the list of ports here.
all - Specifies that all the ports will be used.
strict - Specifies that all the queues will operate in strict mode.
wrr - Specifies that each queue will operate based on their weight settings.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the traffic scheduling mechanism for each CoS queue:
DGS-3620-28PC:admin# config scheduling_mechanism strict
Command: config scheduling_mechanism strict
Success.
To configure the traffic scheduling mechanism for the CoS queue on port 1:1:
DGS-3620-28PC:admin# config scheduling_mechanism ports 1:1 strict
Command: config scheduling_mechanism ports 1:1 strict
Success.
To Next Page
Loading...
Need help?
General