D-Link xStack DGS-3620 Series - Page 1064

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1059
add - Specifies to add a VLAN translation profile.
delete - Specifies to delete a VLAN translation profile.
vlan_translation_profile - Specifies the VLAN translation profile ID.
<profile_id> - Enter the VLAN translation profile ID.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure ports 1 to 4 as NNI ports and set the TPID to 0x88A8:
DGS-3620-28PC:admin#config qinq ports 1-4 role nni outer_tpid 0x88a8
Command: config qinq ports 1-4 role nni outer_tpid 0x88a8
Success.
DGS-3620-28PC:admin#
92-5 config qinq inner_tpid
Description
The command is used to configure the inner TPID of the system. The inner TPID is used to decide
if the ingress packet is c-tagged. Inner tag TPID is per system configurable. This command is used
in the ‘per-system’ TPID configuration.
Format
config qinq inner_tpid <hex 0x1-0xffff>
Parameters
<hex 0x1-0xffff> - Enter the Inner-TPID of the system used here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the inner TPID in the system to 0x9100:
DGS-3620-28PC:admin# config inner_tpid 0x9100
Command: config inner_tpid 0x9100
Success.
DGS-3620-28PC:admin#