D-Link xStack DGS-3620 Series - Page 1119

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1114
101-2 disable sim
Description
This command is used to configure the single IP management on the switch as disabled.
Format
disable sim
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable single IP management:
DGS-3620-28PC:admin#disable sim
Command: disable sim
Success.
DGS-3620-28PC:admin#
101-3 show sim
Description
This command is used to display the information of the specific sorts of devices including of self,
candidate, member, group, and neighbor.
Format
show sim {[candidates {<candidate_id 1-100>} | members {<member_id 1-32>} | group
{commander_mac <macaddr>} | neighbor]}
Parameters
candidates - (Optional) Specifies the candidate devices.
<candidate_id 1-100> - (Optional) Specifies the candidate devices. The ID is from 1 to 100.
members - (Optional) Specifies the member devices.
<member_id 1-32> - (Optional) Specifies the member devices. The ID is from 1 to 32.
group – (Optional) Specifies other group devices.
commander_mac - Specifies the commander MAC address.
<macaddr> - Enter the commander MAC address.
neighbor - (Optional) Specifies other neighbor devices.