D-Link xStack DGS-3620 Series - Page 1200

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1195
110-3 delete super_vlan
Description
This command is used to delete a super VLAN.
Format
delete super_vlan [<vlan_name 32> | vlanid <vlanid 1-4094>]
Parameters
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters long.
vlanid - Specifies the VLAN ID used.
<vlanid 1-4094> - Enter the VLAN ID used here. This value must be between 1 and 4094.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete the super VLAN by specify the VLAN ID 10:
DGS-3620-28PC:admin# delete super_vlan vlanid 10
Command: delete super_vlan vlanid 10
Success.
DGS-3620-28PC:admin#
110-4 config sub_vlan
Description
This command is used to configure the IP or IPv6 address range of the sub-VLAN.
A sub-VLAN can has one or more IP or IPv6 address ranges. Configuring IP or IPv6 address
range of sub-VLAN can reduce the ARP traffic in the super VLAN. The multiple IP or IPv6 address
(ranges) is allowed to map to one sub-VLAN. One IP or IPv6 address can not be mapped to
multiple sub-VLANs, and if one IP or IPv6 address is mapped to multiple VLAN it may cause the
traffic to be forwarded to the wrong VLAN.
Format
config sub_vlan [<vlan_name 32> | vlanid <vlanid 1-4094>] [add | delete] ip_range <ipaddr>
to <ipaddr>| ipv6_range <ipv6addr> to <ipv6addr>]
Parameters
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters long.
vlanid - Specifies the VLAN ID used.
<vlanid 1-4094> - Enter the VLAN ID used here. This value must be between 1 and 4094.
add - Specifies the IP or IPv6 address range of the sub-VLAN that will be added.