D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1239
begin - (Optional) The first line that contains the specified filter string will be the first line of the
output.
<filter_string 80> - Enter a filter string enclosed by the quotation mark symbol. Thus, the filter
string itself cannot contain the quotation mark character. The filter string is case sensitive.
<filter_string 80> - Enter a filter string enclosed by the quotation mark symbol.
<filter_string 80> - Enter a filter string enclosed by the quotation mark symbol.
log_toTFTP - Used to upload a log file from the device to a TFTP server.
<ipaddr> - Enter the IP address of the TFTP server.
<ipv6addr> - Enter the IPv6 address of the TFTP server.
<domain_name 255> - Enter the domain name of the TFTP server here. This name can be
up to 255 characters long.
dest_file - Specifies the path name if the TFTP server.
<path_filename 64> - Enter the path name on the TFTP server. It can be a relative path
name or an absolute path name.
attack_log_toTFTP - Used to upload the attack log to a TFTP server.
<ipaddr> - Enter the IP address of the TFTP server.
<ipv6addr> - Enter the IPv6 address of the TFTP server.
<domain_name 255> - Enter the domain name of the TFTP server here. This name can be
up to 255 characters long.
dest_file - Specifies the path name if the TFTP server.
<path_filename 64> - Enter the path name on the TFTP server. It can be a relative path
name or an absolute path name.
unit - (Optinal) Specifies which unit on the stacking system. If it is not specified, it refers to the
master unit.
<unit_id> - Enter the unit ID used here.
firmware_toTFTP - Used to upload firmware from the device to a TFTP server.
<ipaddr> - Enter the IP address of the TFTP server.
<ipv6addr> - Enter the IPv6 address of the TFTP server.
<domain_name 255> - Enter the domain name of the TFTP server here. This name can be
up to 255 characters long.
dest_file - Specifies the path name if the TFTP server.
<path_filename 64> - Enter the path name if the TFTP server.
unit - (Optinal) Specifies which unit on the stacking system. If it is not specified, it refers to the
master unit.
<unit_id> - Enter the unit ID used here.
src_file - (Optional) Specifies an absolute path name on the device file system. If the path name
is not specified, it refers to the boot up image.
<pathname> - Enter an absolute path name on the device file system. If the path name is not
specified, it refers to the boot up image.
Restrictions
Only Administrator, Operator level users can issue this command.
Example
To upload firmware from a file system device to a TFTP server:
DGS-3620-28PC:admin#upload firmware_toTFTP 10.1.1.1 dest_file D:\firmware.had
src_file 3.00.004.had
Command: upload firmware_toTFTP 10.1.1.1 dest_file D:\firmware.had src_file
3.00.004.had
Connecting to server.................. Done.
Upload firmware....................... Done.
DGS-3620-28PC:admin#

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English