D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1241
<ipaddr> - (Optional) Enter the IP address used for the configuration here.
dest_file – Specifies the destination file used.
<path_filename 64> - The pathname specifies the pathname on the RCP server or local
device.
rcp: - Syntax: rcp: username@ipaddr/directory/filename. Example for FULL path:
user_name@10.1.1.1/home/user_name/desxxxx.had. Example for relative path:
user_name@10.1.1.1./desxxxx.had. Note: Do not use any blank spaces in the <string>.
<string 128> - Enter the RCP string here.
unit - (Optinal) Specifies which unit on the stacking system. If it is not specified, it refers to the
master unit.
<unit_id 1-12> - Enter the unit ID used here. This value must be between 1 and 12.
Restrictions
Only Administrators and Operators can issue this command.
Example
To upload the attack log from the device to an RCP server:
DGS-3620-28PC:admin# upload attack_log_toRCP username rcp_user 172.18.212.104
dest_file /home/DGS-3620.log unit 2
Command: upload attack_log_toRCP username rcp_user 172.18.212.104 dest_file
/home/DGS-3620.log unit 2
Connecting to server.......... Done.
Upload Attack log............. Done.
Success.
DGS-3620-28PC:admin#
119-6 upload cfg_toRCP
Description
This command is used to upload a configuration file from the device to a Remote Copy Protocol
(RCP) server.
Format
upload cfg_toRCP [{username <username>} {<ipaddr>} dest_file <path_filename 64> | rcp:
<string 128>] {unit <unit_id 1-12>} {src_file <pathname>} {[include | exclude | begin]
<filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include | exclude | begin]
<filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include | exclude | begin]
<filter_string 80> {<filter_string 80> {<filter_string 80>}}}}}
Parameters
username - (Optional) Specifies the remote user name on the RCP server.
<username> - Enter the remote user name on the RCP server.
<ipaddr> - (Optional) Specifies the IP address of the RCP server.
dest_file - Specifies the path name on the RCP server. Note: If a user specifies the relative file
path, the path search strategy will depend on the server system. For some systems, the
current user working directory will be searched first, followed by the environment paths.
<path_filename 64> - Enter the path name on the RCP server or local RCP client.

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English