D-Link xStack DGS-3620 Series - Page 1269

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1264
Example
To configure VRRP:
DGS-3620-28PC:admin# config vrrp vrid 1 ipif System state enable
Command: config vrrp vrid 1 ipif System state enable
Success.
DGS-3620-28PC:admin#
120-5 config vrrp ipif
Description
This command is used to configure a virtual router authentication type on an interface.
Format
config vrrp ipif <ipif_name 12> [authtype [none | simple authdata <string 8> | ip authdata
<string 16>]]
Parameters
ipif - Specifies the name of IP interface used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
authtype - Specifies the VRRP’s authentication type.
none - Specifies that no authentication algorithm will be used on this interface.
simple - Specifies that the authentication algorithm will be set to simple text on this interface.
authdata - Specifies the authentication data used in the simple text authentication
algorithm.
<string 8> - Enter the authentication data used in the simple text authentication
algorithm here. This value can be up to 8 characters long.
ip - Specifies that the authentication algorithm will be set to IP authentication header on this
interface.
authdata - Specifies the authentication data used in the IP authentication header
algorithm.
<string 16> - Enter the authentication data used in the IP authentication header
algorithm here. This value can be up to 16 characters long.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a VRRP IP interface:
DGS-3620-28PC:admin# config vrrp ipif System authtype simple authdata 12345678
Command: config vrrp ipif System authtype simple authdata 12345678
Success.
DGS-3620-28PC:admin#