xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1298
To set voice VLAN ports 4 to 6 to auto mode:
DGS-3620-28PC:admin#config voice_vlan ports 4-6 mode auto
Command: config voice_vlan ports 4-6 mode auto
Success.
124-6 config voice_vlan log state
Description
This command is used to configure the voice VLAN log state.
Format
config voice_vlan log state [enable | disable]
Parameters
enable - Specifies to enable the voice VLAN log state.
disable - Specifies to disable the voice VLAN log state.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the voice VLAN log state:
DGS-3620-28PC:admin#config voice_vlan log state enable
Command: config voice_vlan log state enable
Success.
124-7 config voice_vlan aging_time
Description
This command is used to set the aging time of the voice VLAN. The aging time is used to remove
a port from voice VLAN if the port is an automatic VLAN member. When the last voice device
stops sending traffic and the MAC address of this voice device is aged out, the voice VLAN aging
timer will be started. The port will be removed from the voice VLAN after expiration of voice VLAN
aging timer. If the voice traffic resumes during the aging time, the aging timer will be reset and stop.
Format
config voice_vlan aging_time <min 1-65535>
To Next Page
Loading...
Need help?
General