xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1318
125-20 config wac trap state
Description
This command is used to enable or disable the WAC trap state.
Format
config wac trap state [enable | disable]
Parameters
enable – Specifies to enable the WAC trap state.
disable – Specifies to disable the WAC trap state.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
This example show how to enable the WAC trap state.
DGS-3620-28PC:admin# config wac trap state enable
Command: config wac trap state enable
Success.
To Next Page
Loading...
