D-Link xStack DGS-3620 Series - Page 1340

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1335
stacking system.
portNum: 1.Interger value;
2.Represent the logic port number of the
device.
link state: for ex: , 100Mbps FULL duplex
Event description: Port link down.
Log Message: Port <[unitID:]portNum> link down
Parameters description:
unitID: 1.Interger value;2.Represent the id of the device in the
stacking system.
portNum: 1.Interger value;
2.Represent the logic port number of the
device.
Informational
802.1X
Event description: 802.1X Authentication failure.
Log Message: 802.1X Authentication failure [for <reason> ] from
(Username: <username>, Port: <[unitID:]portNum>, MAC:
<macaddr> )
Parameters description:
reason: The reason for the failed authentication.
username: The user that is being authenticated.
unitID: The unit ID.
portNum: The switch port number.
macaddr: The MAC address of thr authenticated device.
Warning
Event description: 802.1X Authentication successful.
Log Message: 802.1X Authentication successful from (Username:
<username>, Port: <[unitID:]portNum>, MAC: <macaddr>)
Parameters description:
username: The user that is being authenticated.
unitID: The unit ID.
portNum: The switch port number.
macaddr: The MAC address of the authenticated device.
Informational
RADIUS
Event description: VID assigned from RADIUS server after
RADIUS client is authenticated by RADIUS server
successfully .This VID will be assigned to the port a
nd this port will
be the VLAN untagged port member.
Log Message: RADIUS server <ipaddr> assigned VID :<vlanID>
to port <[unitID:]portNum> (account :<username> )
Parameters description:
ipaddr: The IP address of the RADIUS server.
vlanID: The VID of RADIUS assigned VLAN.
unitID: The unit ID.
portNum: The port number.
Username: The user that is being authenticated.
Informational
Event description: Ingress bandwidth assigned from RADIUS
server after RADIUS client is authenticated by RADIUS server
successfully .This Ingress bandwidth will be assigned to the port.
Log Message: RADIUS server <ipaddr> assigned ingress
bandwith :<ingressBandwidth> to port <[unitID:]portNum>
(account : <username>)
Parameters description:
ipaddr: The IP address of the RADIUS server.
ingressBandwidth: The ingress bandwidth of RADIUS assign.
unitID: The unit ID.
portNum: The port number.
Username: The user that is being authenticated.
Informational
Event description: Egress bandwidth assigned from RADIUS
server after RADIUS client is authenticated by RADIUS server
successfully .This egress bandwidth will be assigned to the port.
Log Message: RADIUS server <ipaddr> assigned egress
bandwith :<egressBandwidth> to port <[unitID:]portNum>
(account: <username>)
Parameters description:
ipaddr: The IP address of the RADIUS server.
egressBandwidth: The egress bandwidth of RADIUS assign.
unitID: The unit ID.
portNum: The port number.
Username: The user that is being authenticated.
Informational
Event description: 802.1p default priority assigned from RADIUS
server after RADIUS client is authenticated by RADIUS server
successfully. This 802.1p default priority will be assigned to the
port.
Informational