D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
173
Format
delete bgp aggregate_address [[<network_address> | all] | ipv6 [<ipv6_networkaddr> | all]]
Parameters
<network_address> - Specifies the IPv4 aggregated network to be deleted.
all – Specifies that all IPv4 aggregated networks will be deleted..
ipv6 – Specifies the IPv6 network address of the entry that will be deleted.
<ipv6_networkaddr> - Enter the IPv6 network address used here.
all – Specifies that all IPv6 aggregated networks will be deleted.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To delete an aggregate_route of which the network address is 10.0.0.0/8:
DGS-3620-28PC:admin# delete bgp aggregate_address 10.0.0.0/8
Command: delete bgp aggregate_address 10.0.0.0/8
Success.
DGS-3620-28PC:admin#
12-10 show bgp aggregate_address
Description
This command is used to show the aggregate entries in the Border Gateway Protocol (BGP)
database.
Format
show bgp aggregate_address {[<network_address> | ipv6 {<ipv6_networkaddr>}]}
Parameters
<network_address> - (Optional) Specifies the IP aggregated network address.
ipv6 – (Optional) Specifies the IPv6 aggregated network address.
<ipv6_networkaddr> - Enter the IPv6 aggregated network address used here.
If the specific network address is not specified, all aggregated addresses of IPv4 or IPv6 will be
displayed.
Restrictions
None. (EI Mode Only Command)

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English