D-Link xStack DGS-3620 Series - Page 195

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
190
remove_private_as - (Optional) If this setting is set to enable, the private AS number in the AS
path attribute of the BGP update packets will be dropped. By default, the setting is disabled.
enable - Specifies that the 'remove private AS' option will be enabled.
disable - Specifies that the 'remove private AS' option will be disabled.
allowas_in - (Optional) If the allow_as setting is enabled, the BGP router’s self AS is allowed in
the AS path list. By default, the allow_as setting is disabled. If no number is supplied, the
default value of 3 times is used.
enable - Specifies that the allow AS-in option will be enabled.
<value 1-10> - Enter the allow AS-in value used here. This value must be between 1 and 10.
disable - Specifies that the allow AS-in option will be disabled.
default_originate - (Optional) Specifies to enable or disable the default originate function. By
default, this setting is disabled.
enable - Specifies that the default originate function will be enabled.
route_map - Specifies the route map name.
<map_name 16> - Enter the route map name here. This name can be up to 16
characters long.
disable - Specifies that the default originate function will be disabled.
ipv4 unicast - Specifies to configure the IPv4 unicast address family.
ipv6 unicast - Specifies to configure the IPv6 unicast address family.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
This example shows how to configure the EBGP multi-hop to 2:
DGS-3620-28PC:admin# config bgp neighbor general 10.100.200.1 ebgp_multihop 2
Command: config bgp neighbor general 10.100.200.1 ebgp_multihop 2
Success.
DGS-3620-28PC:admin#
12-25 config bgp neighbor timer
Description
This command is used to configure the BGP neighbor’s timer attribute.
advertisement_interval: If an advertised route is flapping, this usually occurs when an interface is
unstable, a lot of UPDATE and WITHDRAWN messages will be sent. One method to control the
flooding of these messages is to set a minimum advertisement interval.
Format
config bgp neighbor timer [<ipaddr> | <ipv6addr> | peer_group <peer_group_name 16>]
{advertisement_interval [<sec 0-600> | default] | [keepalive <sec 0-65535> holdtime <sec 0-
65535> | default_keepalive_holdtime] | as_origination_interval [<sec 1-600> | default] |
connect [<sec 1-65535> | default]}