xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
223
12-57 clear bgp flap_statistics
Description
The command is used to clear the accumulated penalties for routes that have been received on a
router that has BGP dampening enabled. If no IP/IPv6 address or IP/IPv6 network are specified,
flap statistics of the IPv4 unicast or IPv6 unicast address family are cleared for all routes. If both
the IPv4 unicast and IPv6 unicast are not specified, flap statistics of IPv4 unicast are cleared.
Format
clear bgp flap_statistics {[ipv4 unicast {[<ipaddr> | <network_address>]} | [<ipaddr> |
<network_address>] | ipv6 unicast {[<ipv6addr> | <ipv6_networkaddr>]}]}
Parameters
ipv4 unicast – (Optional) Specifies to clear the dampening information for the IPv4 unicast
address family.
<ipaddr> - Enter the IPv4 address used here.
<network_address> - Enter the IPv4 network address here.
ipv6 unicast – (Optional) Specifies to clear the dampening information for the IPv6 unicast
address family.
<ipv6addr> - Enter the IPv6 address used here.
<ipv6_networkaddr> - Enter the IPv6 network address here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
This is an example to clear the route dampening flap statistics of network 192.168.1.0/24:
DGS-3620-28PC:admin# clear bgp flap_statistics 192.168.1.0/24
Command: clear bgp flap_statistics 192.168.1.0/24
Success.
To Next Page
Loading...
Need help?
General