D-Link xStack DGS-3620 Series - Page 24

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
19
Format
show serial_port
Parameters
None.
Restrictions
None.
Example
To display the console port setting:
DGS-3620-28PC:admin#show serial_port
Command: show serial_port
Baud Rate : 115200
Data Bits : 8
Parity Bits : None
Stop Bits : 1
Auto-Logout : 10 mins
DGS-3620-28PC:admin#
2-13 config serial_port
Description
This command is used to configure the serial bit rate that will be used to communicate with the
management host and the auto logout time for idle connections.
Format
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] | auto_logout [never |
2_minutes | 5_minutes | 10_minutes | 15_minutes]}(1)
Parameters
baud_rate - Specifies the baud rate value. The default baud rate is 115200.
9600 - Specifies a baud rate of 9600.
19200 - Specifies a baud rate of 19200.
38400 - Specifies a baud rate of 38400.
115200 - Specifies a baud rate of 115200.
auto_logout - Specifies the timeout value. The default timeout is 10_minutes.
never - Specifies to never timeout.
2_minutes - Specifies when the idle value is over 2 minutes, the device will auto logout.
5_minutes - Specifies when the idle value over 5 minutes, the device will auto logout.
10_minutes - Specifies when the idle value is over 10 minutes, the device will auto logout.
15_minutes - Specifies when the idle value is over 15 minutes, the device will auto logout.