D-Link xStack DGS-3620 Series - Page 259

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
254
Restrictions
None. (EI Mode Only Command)
Example
To display the configuration of the all-MPs-reply-to-LTR function:
DGS-3620-28PC:admin#show cfm mp_ltr_all
Command: show cfm mp_ltr_all
All MPs reply LTRs: Disabled
DGS-3620-28PC:admin#
15-25 show cfm pkt_cnt
Description
This command is used to display the CFM packet’s RX/TX counters.
Format
show cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Parameters
ports - (Optional) Specifies the port counters to display. If not specified, all ports will be
displayed.
<portlist> - Enter a list of ports.
rx - (Optional) Display the RX counter. If not specified, both the RX and TX counters will be
displayed.
tx - (Optional) Display the TX counter. If not specified, both the RX and TX counters will be
displayed.
rx - (Optional) Display the RX counter. If not specified, both the RX and TX counters will be
displayed.
tx - (Optional) Display the TX counter. If not specified, both the RX and TX counters will be
displayed.
ccm - (Optional) Display the CCM RX counters.
Restrictions
None. (EI Mode Only Command)
Example
To display CFM packet RX/TX counters for ports 1 to 2:
DGS-3620-28PC:admin#show cfm pkt_cnt ports 1-2
Command: show cfm pkt_cnt ports 1-2
CFM RX Statistics
------------------------------------------------------------------------------