xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
326
DGS-3620-28PC:admin# debug vrrp vr_state_change state enable
Command: debug vrrp vr_state_change state enable
Success.
To enable all VRRP packet debug flags:
DGS-3620-28PC:admin# debug vrrp packet all state enable
Command: debug vrrp packet all state enable
Success.
To enable VRRP virtual MAC address update debug flag:
DGS-3620-28PC:admin# debug vrrp mac_addr_update state enable
Command: debug vrrp mac_addr_update state enable
Success.
To enable VRRP interface state change debug flag:
DGS-3620-28PC:admin# debug vrrp interface_change state enable
Command: debug vrrp interface_change state enable
Success.
To enable VRRP timer debug flag:
DGS-3620-28PC:admin# debug vrrp timers state enable
Command: debug vrrp timers state enable
Success.
20-31 debug vrrp clear counter
Description
This command is used to reset the VRRP debug statistic counters.
To Next Page
Loading...
