xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
337
20-44 debug bgp show peer_group
Description
This command is used for displaying current peer group’s configuration in BGP protocol stack.
Format
debug bgp show peer_group {ipv6 unicast}
Parameters
ipv6 unicast – (Optional) Specifies to debug the IPv6 unicast address family.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
Configure BGP to show peer group’s configuration:
To Next Page
Loading...
