D-Link xStack DGS-3620 Series - Page 356

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
351
DGS-3620-28PC:admin# debug dhcpv6_relay state disable
Command: debug dhcpv6_relay state disable
Success.
DGS-3620-28PC:admin#
20-63 debug dhcpv6_relay hop_count state
Description
This command is used to enable or disable debug information flag about the hop count.
Format
debug dhcpv6_relay hop_count state [enable | disable]
Parameters
state - Specifies the hop count debugging state.
enable - Specifies that the hop count state will be enabled.
disable - Specifies that the hop count state will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable debug information flag about the hop count:
DGS-3620-28PC:admin# debug dhcpv6_relay hop_count state enable
Command: debug dhcpv6_relay hop_count state enable
Success.
DGS-3620-28PC:admin#
20-64 debug dhcpv6_relay output
Description
Used to set debug message to output to buffer or console.
Format
debug dhcpv6_relay output [buffer | console]
Parameters
output - Specifies the location of the debug message output.
buffer - Let the debug message output to buffer.