D-Link xStack DGS-3620 Series - Page 374

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
369
21-2 config dhcp_local_relay vlan vlanid
Description
This command is used to enable or disable the DHCP local relay function for a specified VLAN ID.
Format
config dhcp_local_relay vlan vlanid <vlan_id 1-4094> state [enable | disable]
Parameters
vlanid - Specifies the VLAN ID used to enabled DHCP local relay.
<vlan_id 1-4094> - Enter the VLAN ID used here. This value must be between 1 and 4094.
state - Enable or disable DHCP local relay for a specified VLAN.
enable - Enable DHCP local relay for a specified VLAN.
disable - Disable DHCP local relay for a specified VLAN.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable DHCP local relay for the default VLAN:
DGS-3620-28PC:admin#config dhcp_local_relay vlan vlanid 1 state enable
Command: config dhcp_local_relay vlan vlanid 1 state enable
Success.
DGS-3620-28PC:admin#
21-3 enable dhcp_local_relay
Description
This command is used to globally enable the DHCP local relay function on the switch.
Format
enable dhcp_local_relay
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the DHCP local relay function: