D-Link xStack DGS-3620 Series - Page 394

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
389
Example
To display the DHCP relay state of ports 1 to 10:
DGS-3620-28PC:admin#show dhcp_relay ports 1:1-1:10
Command: show dhcp_relay ports 1:1-1:10
Port DHCP Relay State
---- ----------------
1:1 Enabled
1:2 Enabled
1:3 Enabled
1:4 Enabled
1:5 Enabled
1:6 Enabled
1:7 Enabled
1:8 Enabled
1:9 Enabled
1:10 Enabled
Total Entries : 10
DGS-3620-28PC:admin#
22-24 config dhcp_relay unicast
Description
This command is used to Configure the state for processing DHCP unicast packets from client.
Format
config dhcp_relay unicast [enable | disable]
Parameters
enable - DHCP unicast packet will be processed by DHCP relay and local relay function. This is
the default value.
disable - DHCP relay/local relay function will not process DHCP unicast packet.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable the DHCP relay and local relay agent to process the DHCP unicast packet:
DGS-3620-28PC:admin#config dhcp_relay unicast disable
Command: config dhcp_relay unicast disable
Success.
DGS-3620-28PC:admin#