D-Link xStack DGS-3620 Series - Page 41

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
36
Format
config 802.1x auth_protocol [local | radius_eap]
Parameters
local - Specifiy the authentication protocol as local.
radius_eap - Specifies the authentication protocol as RADIUS EAP.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the 802.1X RADIUS EAP:
DGS-3620-28PC:admin#config 802.1x auth_protocol radius_eap
Command: config 802.1x auth_protocol radius_eap
Success.
DGS-3620-28PC:admin#
3-7 show 802.1x
Description
This command is used to display the 802.1X state or configurations.
Format
show 802.1x {[auth_state | auth_configuration] ports {<portlist>}}
Parameters
auth_state - (Optional) Specifies to display the 802.1X authentication state of some or all ports.
auth_configuration - (Optional) Specifies to display 802.1X configuration of some or all ports.
ports - (Optional) Specifies a range of ports to be displayed.
<portlist> - Enter a range of ports to be displayed.
Restrictions
None.
Example
To display 802.1X information:
DGS-3620-28PC:admin#show 802.1x
Command: show 802.1x
802.1X : Disabled