D-Link xStack DGS-3620 Series - Page 410

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
405
23-22 show dhcp pool manual_binding
Description
This command is used to display the configured manual binding entries.
Format
show dhcp pool manual_binding {<pool_name 12>}
Parameters
<pool_name 12> - (Optional) Specifies the DHCP pool name.
Restrictions
None.
Example
To display the configured manual binding entries:
DGS-3620-28PC:admin#show dhcp pool manual_binding
Command: show dhcp pool manual_binding
Pool Name IP Address Hardware Address Type
------------ ------------- ------------------ --------
p1 192.168.0.1 00-80-C8-08-13-88 Ethernet
p1 192.168.0.2 00-80-C8-08-13-99 Ethernet
Total Entries : 2
DGS-3620-28PC:admin#
23-23 enable dhcp_server
Description
This command is used to enable the DHCP server function.
If DHCP relay is enabled, DHCP server cannot be enabled. The opposite is also true. For Layer 2
switches, if DHCP client is enabled on the only interface, then DHCP server cannot be enabled.
For layer 3 switches, when the System interface is the only interface then can DHCP client be
enabled. If the DHCP client is enabled, then the DHCP server cannot be enabled.
Format
enable dhcp_server
Parameters
None.