D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
422
Format
config filter icmpv6_ra_all_node ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of ports, used for this configuration, here.
all - Specifies that all ports will be used for this configuration.
state - Specifies whether the port’s filter ICMPv6 RA all-nodes packets function is enabled or
disabled.
enable - Specifies that the filter ICMPv6 RA all-nodes packets function is be enabled.
disable - Specifies that the filter ICMPv6 RA all-nodes packets function is be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the filter ICMPv6 RA all-nodes state to enabled for ports 1 to 8:
DGS-3620-28PC:admin#config filter icmpv6_ra_all_node ports 1:1-1:8 state enable
Command: config filter icmpv6_ra_all_node ports 1:1-1:8 state enable
Success.
DGS-3620-28PC:admin#
24-14 config filter icmpv6_ra_all_node trap
Description
This command is used to enable or disable the filter ICMPv6 RA all-nodes trap state. If the
ICMPv6 RA all-nodes server trap state is disabled, no trap will be sent out.
Format
config filter icmpv6_ra_all_node trap [enable | disable]
Parameters
enable - Specifies that the trap for the filter ICMPv6 RA all-nodes will be enabled. The trap for
filter ICMPv6 RA all-nodes will be sent out.
disable - Specifies that the trap for the filter ICMPv6 RA all-nodes will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the filter ICMPv6 RA all-nodes trap state:

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English