To Next Page

To Previous Page

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide

428

all - Specifies that all the configured IP interfaces wil be used..

state - Specifies if the DHCPv6 relay state will be enabled or disabled.

enable - Choose this parameter to enable the DHCPv6 relay state of the interface.

disable - Choose this parameter to disable the DHCPv6 relay state of the interface.

Restrictions

Only Administrators, Operators and Power-Users can issue this command.

Example

To configure the DHCPv6 relay state of the System interface to enable:

DGS-3620-28PC:admin# config dhcpv6_relay ipif System state enable

Command: config dhcpv6_relay ipif System state enable

Success.

DGS-3620-28PC:admin#

25-6 show dhcpv6_relay

Description

This command will display the current DHCPv6 relay configuration of all interfaces, or if an IP

interface name is specified, the DHCPv6 relay configuration for that IP interface.

Format

show dhcpv6_relay {ipif <ipif_name 12>}

Parameters

ipif - (Optional) The name of the IP interface for which to display the current DHCPv6 relay

configuration.

<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12

characters long.

If no IP interface is specified, all configured DHCPv6 relay interfaces are displayed.

Restrictions

None.

Example

To show the DHCPv6 relay configuration of all interfaces:

D-Link xStack DGS-3620 Series User Manual

Questions and Answers: