xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
430
Format
config dhcpv6_relay option_37 {state [enable | disable] | check [enable | disable] |
remote_id [default | cid_with_user_define <desc 128>| user_define <desc 128>]}(1)
Parameters
state - Specifies the DHCPv6 relay Option 37 state.
enable - When the state is enabled, the DHCP packet will be inserted with the Option 37 field
before being relayed to server.
disable - When the state is disabled, the DHCP packet will be relayed directly to server
without further checks and inserted with the Option 37.
check - Specifies that packets coming from client side should or should not have the Option 37
field. If client originating packets have the Option 37 field set they will be dropped.
enable - Specifies that the check option is enabled.
disable - Specifies that the check option is disabled.
remote_id - Specifies the content in the Remote ID.
default - Specifies that the remote ID will contain the VLAN ID, Module, Port, and System
MAC address of the device.
cid_with_user_define - Specifies that the remote ID will contain the VLAN ID, Module, Port,
and a user defined string.
<desc 128> - Enter the CID user defined string here. This can be up to 128 characters
long.
user_define - Specifies that the remote ID will be a user defined string.
<desc 128> - Enter the user defined string here. This can be up to 128 characters long.0
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the state of the DHCPv6 Option 37:
DGS-3620-28PC:admin#config dhcpv6_relay option_37 state enable
Command: config dhcpv6_relay option_37 state enable
Success.
To enable the DHCPv6 Option 37 check:
DGS-3620-28PC:admin#config dhcpv6_relay option_37 check enable
Command: config dhcpv6_relay option_37 check enable
Success.
To set the remote ID as default:
To Next Page
Loading...
Need help?
General