D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
445
Example
To display the excluded address information:
DGS-3620-28PC:admin# show dhcpv6 excluded_address
Command: show dhcpv6 excluded_address
Pool Name: net100
Range 1
Begin Address: 3000:110:1::1
End Address : 3000:110:1::7
Range 2
Begin Address: 3000:110:1::9
End Address : 3000:110:1::9
Range 3
Begin Address: 3000:110:1::11
End Address : 3000:110:1::11
Range 4
Begin Address: 3000:110:1::13
End Address : 3000:110:1::13
Total Entries : 5
DGS-3620-28PC:admin#
26-18 config dhcpv6_server ipif
Description
This command is used to configure the DHCPv6 Server state per interface.
Format
config dhcpv6_server ipif [<ipif_name 12> | all] state [enable | disable]
Parameters
ipif - Specifies the IP interface used.
<ipif_name 12> - Enter the IP interface name used. This name can be up to 12 characters
long.
all - Specifies that all the IP interfaces will used.
state - Specifies the DHCPv6 server state for the specified interface.
enable - Specifies that the DHCPv6 server state for the specified interface will be enabled.
disable - Specifies that the DHCPv6 server state for the specified interface will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the DHCPv6 Server state of System Interface to enable:

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English