xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
453
DGS-3620-28PC:admin#show ddm ports 1:21 configuration
Command: show ddm ports 1:21 configuration
Port: 1:21
--------------------------------------------
DDM State : Enabled
Shutdown : Alarm
Threshold Temperature Voltage Bias-Current TX-Power RX-Power
(in Celsius) (V) (mA) (mW) (mW)
------------- ------------ ------------ ------------ ------------ ------------
High Alarm 84.9555(A) 4.2500(A) 7.2500(A) 0.6250(A) 4.5500(A)
Low Alarm -10.0000(A) 2.5000(A) 0.0040(A) 0.0060(A) 0.0100(A)
High Warning 70.0000(A) 3.5000(A) 0.5000(A) 0.5500(A) 3.5000(A)
Low Warning 2.2525(A) 3.0000(A) 0.0080(A) 0.0080(A) 0.0300(A)
A means that the threshold is administratively configured.
27-5 config ddm power_unit
Description
The command is used to configure the unit of DDM TX and RX power.
Format
config ddm power_unit [mw | dbm]
Parameters
mw - Specifies the DDM TX and RX power unit as mW.
dbm - Specifies the DDM TX and RX power unit as dBm.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the DDM TX and RX power unit as dBm:
DGS-3620-28PC:admin#config ddm power_unit dbm
Command: config ddm power_unit dbm
Success.
To Next Page
Loading...
Need help?
General