xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
487
Example
To set the log state:
DGS-3620-28PC:admin#config erps log enable
Command: config erps log enable
Success.
34-7 config erps trap
Description
This command is used to configure trap state of ERPS events.
Format
config erps trap [enable | disable]
Parameters
trap - Specifies to enable or disable the ERPS trap state.
enable - Enter enable to enable the trap state.
disable - Enter disable to disable the trap state. The default value is disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the trap state of the ERPS:
DGS-3620-28PC:admin# config erps trap enable
Command: config erps trap enable
Success.
34-8 show erps
Description
This command is used to display ERPS configuration and operation information. The port state of
the ring port may be as Forwarding, Blocking, or Signal Fail. Forwarding indicates that traffic is
able to be forwarded. Blocking indicates that traffic is blocked by ERPS and a signal failure is not
detected on the port. Signal Fail indicates that a signal failure is detected on the port and traffic is
blocked by ERPS.
To Next Page
Loading...
Need help?
General