D-Link xStack DGS-3620 Series - Page 566

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
561
DGS-3620-28PC:admin#config igmp access_authentication ports all state enable
Command: config igmp access_authentication ports all state enable
Success.
DGS-3620-28PC:admin#
45-20 show igmp access_authentication ports
Description
This command is used to display the current IGMP Access Control configuration.
Format
show igmp access_authentication ports [all | <portlist>]
Parameters
all - Specifies all ports to be displayed.
<portlist> - Enter a range of ports to be displayed.
Restrictions
None.
Example
To display the IGMP Access Control status for ports 1-4:
DGS-3620-28PC:admin#show igmp access_authentication ports 1:1-1:4
Command: show igmp access_authentication ports 1:1-1:4
Port State
----- ---------
1:1 Auth_accounting
1:2 Disabled
1:3 Disabled
1:4 Disabled
DGS-3620-28PC:admin#
To display the IGMP Access Control status for all ports:
DGS-3620-28PC:admin#show igmp access_authentication ports all
Command: show igmp access_authentication ports all
Port State
----- ---------
1:1 Auth_accounting
1:2 Disabled
1:3 Disabled