EasyManua.ls Logo

D-Link xStack DGS-3620 Series - Page 577

D-Link xStack DGS-3620 Series
1371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
572
If no parameter is specified, the system will display all multicast VLANs.
Restrictions
None.
Example
To display all IGMP snooping multicast VLANs:
DGS-3620-28PC:admin# show igmp_snooping multicast_vlan
Command: show igmp_snooping multicast_vlan
IGMP Multicast VLAN Global State : Enabled
IGMP Multicast VLAN Forward Unmatched : Disabled
IGMP Multicast VLAN Auto Assign VLAN : Enabled
VLAN Name :4094
VID :4094
Member(Untagged) Ports :2:20-2:21
Tagged Member Ports :
Source Ports :2:22
Untagged Source Ports :
Status :Enabled
Replace Source IP :4.4.4.4 (User Configure)
Remap Priority :7 (Replaced)
Total Entries: 1
DGS-3620-28PC:admin#
46-13 config igmp_snooping multicast_vlan forward_unmatched
Description
This command is used to configure the forwarding mode for IGMP snooping multicast VLAN
unmatched packets. When the switch receives an IGMP snooping packet, it will match the packet
against the multicast profile to determine which multicast VLAN to associate with. If the packet
does not match all profiles, the packet will be forwarded or dropped based on this setting. By
default, the packet will be dropped.
Format
config igmp_snooping multicast_vlan forward_unmatched [disable | enable]
Parameters
enable - The packet will be flooded on the VLAN.
disable - The packet will be dropped.

Table of Contents

Related product manuals