D-Link xStack DGS-3620 Series - Page 648

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
643
Format
config address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports
[<portlist>| all ]}
Parameters
<ipaddr> - Enter the IP address.
mac_address - Specifies the MAC address.
<macaddr> - Enter the MAC address here.
ports - (Optional) Configure the portlist to apply, if ports are not configured, then it will apply to all
ports.
<portlist> - Enter the list of ports to apply.
all - Specifies to apply to all the ports.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure an address binding entry:
DGS-3620-28PC:admin#config address_binding ip_mac ipaddress 10.1.1.1
mac_address 00-00-00-00-00-11
Command: config address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-
00-00-11
Success.
DGS-3620-28PC:admin#
53-5 config address_binding ip_mac ipv6address
Description
This command is used to update an address binding entry using IPv6.
Format
config address_binding ip_mac ipv6address <ipv6addr> mac_address <macaddr> {ports
[<portlist> | all]}
Parameters
ipv6address - Specifies the IPv6 address used.
<ipv6addr> - Enter the IPv6 address used here.
mac_address - Specifies the MAC address.
<macaddr> - Enter the MAC address here.
ports - (Optional) Configure the portlist to apply, if ports are not configured, then it will apply to all
ports.
<portlist> - Enter the list of ports to apply.
all - Specifies to apply to all the ports.