D-Link xStack DGS-3620 Series - Page 651

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
646
53-8 show address_binding
Description
This command is used to display address binding information.
Format
show address_binding {ports {<portlist>}}
Parameters
ports – (Optional) Specifies to display the state of IP MAC port binding for all ports.
<portlist> - Enter the list of ports for the display here.
Restrictions
None.
Example
To display address binding information:
DGS-3620-28PC:admin#show address_binding
Command: show address_binding
Roaming state : Enabled
Trap/Log : Disabled
DHCP Snoop(IPv4) : Disabled
DHCP Snoop(IPv6) : Disabled
ND Snoop : Disabled
Autosave state : Enabled
Save Filename : dhcpsnp.cfg
Function Version : 3.96
DGS-3620-28PC:admin#
To display address binding information for ports 1 to 10:
DGS-3620-28PC:admin#show address_binding ports 1:1-1:10
Command: show address_binding ports 1:1-1:10
ARP:ARP Inspection IP:IP Inspection ND:ND Inspection Prot:Protocol
Port ARP IP ND Prot Zero IP DHCP Packet Stop Learning
Threshold/Mode
----- -------- -------- -------- ---- --------- ----------- --------------
1:1 Disabled Disabled Disabled All Not Allow Forward 500/Normal
1:2 Disabled Disabled Disabled All Not Allow Forward 500/Normal
1:3 Disabled Disabled Disabled All Not Allow Forward 500/Normal
1:4 Disabled Disabled Disabled All Not Allow Forward 500/Normal
1:5 Disabled Disabled Disabled All Not Allow Forward 500/Normal