D-Link xStack DGS-3620 Series - Page 654

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
649
DGS-3620-28PC:admin#
To display the IMPB entry by IP address and MAC address:
DGS-3620-28PC:admin# show address_binding ip_mac ipaddress 10.1.1.1 mac_address
00-00-00-00-00-11
Command: show address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-
00-00-11
M(Mode) – D:DHCP,N:ND,S:Static ACL - A:Active I:Inactive
IP Address MAC Address M ACL Ports
--------------------------------------- ----------------- -- -- --------------
10.1.1.1 00-00-00-00-00-11 S I 1,3,5,7,8
Total Entries : 1
DGS-3620-28PC:admin#
53-11 enable address_binding trap_log
Description
This command is used to send trap and log messages when an address binding module detects
illegal IP and MAC addresses.
Format
enable address_binding trap_log
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the address binding trap and log:
DGS-3620-28PC:admin#enable address_binding trap_log
Command: enable address_binding trap_log
Success.
DGS-3620-28PC:admin#