D-Link xStack DGS-3620 Series - Page 686

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
681
Example
To configure the JWAC port state:
DGS-3620-28PC:admin#config jwac ports 1-9 state enable
Command: config jwac ports 1-9 state enable
Success.
DGS-3620-28PC:admin#
54-18 config jwac radius_protocol
Description
This command is used to specify the RADIUS protocol used by JWAC to complete RADIUS
authentication.
Format
config jwac radius_protocol [local | eap_md5 | pap | chap | ms_chap | ms_chapv2]
Parameters
local - Specifies the JWAC switch uses the local user DB to complete the authentication.
eap_md5 - Specifies the JWAC switch uses EAP MD5 to communicate with the RADIUS server.
pap - Specifies the JWAC switch uses PAP to communicate with the RADIUS server.
chap - Specifies the JWAC switch uses CHAP to communicate with the RADIUS server.
ms_chap - Specifies the JWAC switch uses MS-CHAP to communicate with the RADIUS server.
ms_chapv2 - Specifies the JWAC switch uses MS-CHAPv2 to communicate with the RADIUS
server.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the RADIUS protocol used by JWAC:
DGS-3620-28PC:admin# config jwac radius_protocol ms_chapv2
Command: config jwac radius_protocol ms_chapv2
Success.
DGS-3620-28PC:admin#
54-19 create jwac user
Description
This command creates JWAC users in the local database. When “local” is chosen while
configuring the JWAC RADIUS protocol, the local database will be used.