D-Link xStack DGS-3620 Series - Page 699

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
694
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable Jumbo Frames:
DGS-3620-28PC:admin#disable jumbo_frame
Command: disable jumbo_frame
Success.
DGS-3620-28PC:admin#
55-3 config jumbo_frame ports
Description
This command is used to configure the jumbo frame state on specified ports.
Format
config jumbo_frame ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of ports used for this configuration here.
all - Specifies that all the ports will be used for this configuration.
state - Specifies the jumbo frame state to be applied to a range of ports specified.
enable - Specifies that the jumbo frame state will be enabled.
disable - Specifies that the jumbo frame state will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable jumbo frames on ports 1:1-1:5:
DGS-3620-28PC:admin# config jumbo_frame ports 1:1-1:5 state enable
Command: config jumbo_frame ports 1:1-1:5 state enable
Success.
DGS-3620-28PC:admin#
55-4 show jumbo_frame
Description
This command is used to display Jumbo Frames.