D-Link xStack DGS-3620 Series - Page 704

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
699
<value 0-65535> - Enter the threshold packets-per-seconds value here. This value must be
between 0 and 65535.
nni - Specifies the port is NNI port
none - Disables tunnel on it. By default, a port is none port.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the STP tunneling on ports 1-4:
DGS-3620-28PC:admin# config l2protocol_tunnel ports 1-4 type uni
tunneled_protocol stp
Command: config l2protocol_tunnel ports 1-4 type uni tunneled_protocol stp
Success.
DGS-3620-28PC:admin#
57-2 show l2protocol_tunnel
Description
This command is used to show Layer 2 protocol tunneling information.
Format
show l2protocol_tunnel {[uni | nni]}
Parameters
uni - (Optional) Specifies show UNI detail information, include tunneled and dropped PDU
statistic.
nni - (Optional) Specifies show NNI detail information, include de-capsulated Layer 2 PDU
statistic.
Restrictions
None.
Example
To show Layer 2 protocol tunneling information summary: