D-Link xStack DGS-3620 Series - Page 733

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
728
DGS-3620-28PC:admin#config lldp_med fast_start repeat_count 5
Command: config lldp_med fast_start repeat_count 5
Success.
DGS-3620-28PC:admin#
60-10 config lldp_med log state
Description
This command is used to configure the log state of LLDP-MED events.
Format
config lldp_med log state [enable | disable]
Parameters
enable - Enable the log state for LLDP-MED events.
disable - Disable the log state for LLDP-MED events. The default is disabled.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable the log state of LLDP-MED events:
DGS-3620-28PC:admin#config lldp_med log state enable
Command: config lldp_med log state enable
Success.
DGS-3620-28PC:admin#
60-11 config lldp_med notification topo_change ports
Description
This command is used to enable or disable each port for sending topology change notification to
configured SNMP trap receiver(s) if an endpoint device is removed or moved to another port. The
default state is disabled.
Format
config lldp_med notification topo_change ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter a range of ports to be configured.